Polysoude P6 - Table of Illustrations

THE ART OF WELDING
P6
88-92 PN-0509076 Rev. 16
Table of illustrations
Fig. 3.1 - P6 HW power source ........................................................................................... 12
Fig. 3.2 - P6 power source ................................................................................................. 13
Fig. 3.3 - P4 power source ................................................................................................. 13
Fig. 3.4 - MU IV welding head ............................................................................................ 16
Fig. 3.5 - Polycar welding carriage ...................................................................................... 16
Fig. 3.6 - MW welding head ................................................................................................ 16
Fig. 3.7 - TS 34 welding head ............................................................................................. 17
Fig. 3.8 - TS 2000 welding head ......................................................................................... 17
Fig. 3.9 - TS 8/75 welding head .......................................................................................... 17
Fig. 3.10 - Polyfi l-3 wire feeder .......................................................................................... 17
Fig. 3.11 - Description of P6 power source ........................................................................... 18
Fig. 3.12 - P6 remotes control unit ...................................................................................... 19
Fig. 4.1 - Accessories supplied with the power source P6 ....................................................... 21
Fig. 4.2 - Rating plate of the P6 power source ...................................................................... 22
Fig. 4.3 - Transformer coupling ........................................................................................... 23
Fig. 4.4 - Layout of coupling terminal block .......................................................................... 23
Fig. 4.5 - Connection of the gas supply to the power source P6 ............................................... 25
Fig. 4.6 - Connection diagram if one gas is used ................................................................... 25
Fig. 4.7 - Connection diagram if two different gases are used ................................................. 25
Fig.4.8 - Memo Axis confi guration standard .......................................................................... 29
Fig. 4.9 - Connection of the remote control unit to the P6 power source ................................... 30
Fig. 4.10 - Connection of an open welding head of the MU type or a tube/tubesheet welding
head of the type TS or TP................................................................................... 33
Fig. 4.11 - Connection of a gas cooled closed chamber welding head ....................................... 31
Fig. 4.12 - Connection of a liquid cooled closed chamber welding head .................................... 34
Fig. 4.13 - Connection of a liquid cooled closed chamber welding head with integrated com-
mand buttons ................................................................................................... 35
Fig. 4.14 - Connection of a wire feed unit............................................................................. 36
Fig. 4.15 - Connection of a closed chamber welding head equipped with tacheometry ................ 37
Fig. 4.16 - Connection of a manual torch ............................................................................ 38
Fig. 4.17 - Power source rear connection panel and oxygen meter ........................................... 40