THE ART OF WELDING
P6
30-92 PN-0509076 Rev. 16
Setting to work4. 4.
Remotes control on board4. 4. 1.
When using the remote control board on TS, MW and hand torches,
must keep pressing the button for one second that action be taken into
account
Connection of the remote control unit 4. 4. 2.
The cable of the remote control unit is connected by means of a bayonet fi tting on the connector panel.
Power sources equipped with the emergency stop option cannot be powered up if the remote control unit is not
connected.
Fig. 4.9 - Connection of the remote control unit to the P6 power source
To Next Page
Loading...
