THE ART OF WELDING
P6
80-92 PN-0509076 Rev. 16
Error and codes processing7. 1.
Cause Code Fault Consequence
Gas
4097 Gas fl owmeter not present (1) Stop
4465 Oxygen error (1) Stop
4673 Oxygen error (2) Stop
4529 Gas fl owmeter not present (2) Stop
Cooling
4113 Cooling fl owmeter not present (1) Imposed downslope
4129 Cooling level too low (1) Stop
4145 Cooling temperature too high (1) Imposed downslope
4513 Cooling fl owmeter not present (2) Imposed downslope
Voltage 4161
Short-circuit
Stop
Current
4193
Ignition impossible
Stop
4177 Arc loss Stop
4209
Power supply temperature too high
(Overheating)
Stop
4225 Troubles on supply voltages Stop
Rotation
4241 Control of rotation speed Stop
4273
Rotation overcurrent (Rotation motor
blocked)
Stop
4449 Start open welding head Stop
Wire
4257 Control of wire speed Imposed downslope
4289 Wire overcurrent (Wire motor blocked) Stop
Hot wire 4625 HW error Imposed downslope
Power source
4305 Priority stop Stop
4321 Overvoltage
4337 Undervoltage
4353 Priority stop requested (software)
4369 Control system Stop
4417 Wrong detection of equipment No cycle start
4433
Welding head detection impossible with
extension
4481 Impossible restart No restart
4497 GUI problem
Arc voltage control
(AVC)
4577 High end stop reached Stop
4593 Low end stop reached Stop
Oscillation
4545 Right end stop reached Stop
4561 Left end stop reached Stop
Variator
4689 Variator not ready (absent) Stop
4705 variator connection impossible Stop
To Next Page
Loading...
