1. Reinstall the Moving Arm Pivot Shaft into the pivot shaft mounting bar. Reinstall the Mov-
ing Arm Pivot Shaft inner set screw. Tighten both the inner and outer set screws.
Torque the fastener to 300 in-lbs (34 Nm).
2. Reinstall the Inner Linkarm cover and then the attach the Linkarm to the Moving Arm
Link mount, torque the fastener to 300 +/- 90 in-lbs (34 +/- 10 Nm).
3. Reinstall the Outer Link Arm Cover and secure with the #2 Phillips fastener.
4. Verify machine operation and return to service, see "Operation Verification" on page11.
Experience Series 800 Line EFX
116
5 Replacement Procedures
Moving Arms Replacement
To Next Page
Loading...
