Precor Experience Series 800 line EFX User Manual

1. Remove the stairarm from the crankarm spindle:
a. Remove the #2 Phillips screw fastener and slide the Outer Pivot Block cover rear-
ward and away from the frame to remove. Retain fastener hardware for install-
ation.
b. Remove the #3 Phillips Nylok patch Retention Plate fastener and the Crankarm
Retention Plate. Discard the fastener bolt and retain the Crankarm Retention
Plate for installation.
CAUTION:Do not reuse the removed Retention Plate Nylok patch bolt fasten-
ers for installation. Discard the removed bolts and order new bolts for install-
ation.
c. Use external retaining ring pliers to remove the stairarm pivot block retaining ring.
Retain fastener hardware for installation.
d. Remove the stairarm off the crankarm spindle and carefully lay on the ground.
2. Roll the stairarm down and off the end of the ramp roller track.
3. Remove the linkarm from the stairarm (Moving arm models only):.
a. Remove the #2 Phillips screw fastener and remove the Outer Linkarm Cover.
Retain fastener hardware for installation.
Experience Series 800 Line EFX
119
5 Replacement Procedures
Stairarm Replacement

Precor Experience Series 800 line EFX Specifications

General

Brand	Precor
Model	Experience Series 800 line EFX
Category	Elliptical Trainer
Language	English