2. Reinstall the stairarm rollers onto the ramp. Carefully slide the rollers onto the lower
ramp track and slide up the ramp.
3. Reinstall the stairarm onto the crankarm spindle.
a. Make sure the pivot block inner flat washer and wave washer are installed in the
order shown on the crankarm spindle (flat washer then wave washer). Then slide
the stairarm onto the crankarm spindle.
b. Reinstall the pivot block retaining ring.
c. Reinstall the Crankarm Retention Plate and secure with a new Nylok patch
fastener. Torque to 30 +/- 9 in-lbs (3.4 +/- 1 Nm)
CAUTION:Do not reuse the removed Retention Plate Nylok patch bolt fasteners for
installation. Discard the removed bolts and order new bolts for installation.
2. Reinstall the outer Pivot Block cover and secure with the #2 Phillips screw fastener.
Experience Series 800 Line EFX
121
5 Replacement Procedures
Stairarm Replacement
To Next Page
Loading...
