6. Use a 1/2" socket to loosen the second stage belt tensioner and walk the second stage
drive belt off the pulleys. Remove the second stage drive belt. Rest the pulley on the
crankarm, it is not necessary to remove the belt from the unit. Retain belt for installation.
7. Use a 1/2" socket to remove the Generator and Eddy Brake Assembly lower carriage
bolt fastener. Then slide the assembly down and remove the upper carriage bolt.
Remove the Generator and Eddy Brake Assembly. Retain fastener hardware for install-
ation.
TIP: Remove the lower carriage bolt fastener first and then the upper. The upper bolt
cannot be removed while the lower bolt is installed.
Installation Instructions
1. Reinstall the Generator and Eddy Brake Assembly onto the Step-up Pulley and Ten-
sioner bracket.
2. Slide the assembly down and install the upper carriage bolt. Tighten the bolt enough to
keep the carriage bolt heads inserted into the mounting slot but do not fully tighten. Then
slide the assembly upward and install the lower carriage bolt. Tighten the bolt enough to
keep the carriage bolt heads inserted into the mounting slot but do not fully tighten.
TIP: Install the upper carriage bolt fastener first and then the lower. The upper bolt
cannot be installed when the lower bolt is installed.
3. Walk the second stage drive belt onto the second stage pulleys and tension to 110-120
lbs (50- 54.4 kgs), see "Second Stage Drive Tension Adjustment" on page36.
Experience Series 800 Line EFX
80
5 Replacement Procedures
Generator and Eddy Brake Assembly Replacement
To Next Page
Loading...
Need help?
General
