Precor Experience Series 800 line EFX User Manual

4. Walk the first stage drive belt onto the first stage pulleys and tension the belt to 140-150
lbs (63.5 - 68 kgs), see "First Stage Drive Belt Tension Adjustment" on page32.
5. Fully tighten the two Generator and Eddy Brake Assembly and two Drive Components
Assembly carriage bolt fasteners, torque to 180 in-lbs (20.3 Nm).
6. Reconnect the Generator input cable (J1) and Eddy/Brake load cable (J7) on the LPCA
board. Reinstall the LPCA/Battery module cover and secure with the #2 Phillips screw
fastener.
7. Reinstall the left and right Drive Disk covers, see "Drive Disk Covers Replacement" on
page57.
8. Reinstall the Drive Access cover, see "Drive Access Cover Replacement" on page56.
9. Verify machine operation and return to service, see "Operation Verification" on page11.
Experience Series 800 Line EFX
81
5 Replacement Procedures
Generator and Eddy Brake Assembly Replacement

Precor Experience Series 800 line EFX Specifications

General

Brand	Precor
Model	Experience Series 800 line EFX
Category	Elliptical Trainer
Language	English