AFV
+
Series High Power Programmable AC Power Supply
2-30
Protective Grounding. To protect users, the wire connected to terminal “G” (that
is GND) must be connected to the earth ground. Under no circumstances shall
this product operated without an adequate protective grounding connection.
Figure 2.10 Three phase Input Terminal
2.5 Output Connection
For Output connection, please open the front chassis door and remove the button
front panel which is fixed via screws, then you will find the output terminal as the
Figure 2.11 below. Please connect the output wires to the input of the DUT and
ensure the wires to the DUT must be sufficiently large gauges, so they will not
over-heat while carrying the output current.
Figure 2.11 Single and Three phase Input Terminal
To Next Page
Loading...
