Printronix LP654C

To Next Page

To Previous Page

- 115 -

*1 Factory default setting values are different according to the country or region.

*2 The values are displayed with the unit set in [Admin Setup] - [Tray Setup] - [Unit of Measurement].

Easy Setup

Item

Factory

default

settings

Description

Enter Password

**********

Input the password required to enter the

Admin Setup menu.

Language

Setup

Select Language

English

Selects the display language of the display.

Time Setup

Date Format

yyyy/mm/dd

Sets the date in the format of yyyy/mm/dd.

Time Zone

+9:00

Sets the GMT time zone.

Value range: -12:00 to +13:00 (in

increments of 15 minutes)

Daylight Saving

Off

Sets the daylight saving (daylight saving

time).

Setting method

Manual

Setup

Selects how to set the time.

SNTP Server (Primary)

(Blank)

Sets the SNTP server used to set the

current date and time. Up to 64 characters

can be used.

Displayed when [Auto Config] is selected as

the setting method.

SNTP Server (Secondary)

(Blank)

Time Setting

2001/01/01

00:00:00

The time is set at factory delivery. Change

the date and time if necessary.

Displayed when [Manual Setup] is selected

as the setting method.

Admin

Password

New Password

Input a new admin password.

Verify Password

Input the new admin password again to

verify.

Network

Setup

General

Setup

Extended Network

Disable

Selected when you want to enable any other

network than the standard wired LAN.

Enabling Default Gateway

Wired(LAN1)

Specifies the network connection method for

segment-based communication.

TCP/IP

Enable

Enables/Disables the wired LAN.

NetBIOS over TCP

Enable

Enables/Disables the NetBIOS over TCP

protocol.

Web

Enable

Enables the access from the web browser.