Printronix LP654C - Page 115

- 116 -
Item
Factory
default
settings
Description
Network Scale
Small
Normally, [Small] is selected.
Network Factory Defaults
Execute
Restores network menu settings to factory
default settings.
Wired(LAN1)
Setup
Wired(LAN1)
Enable
Enables/Disables the wired LAN1.
IP Address Set
Auto
Set to obtain the IPv4 address automatically
or input it manually.
IPv4 Address
xxx.xxx.xxx.x
xx
Input the IPv4 address manually. Displayed
when [IP Address Set] is set to [Manual].
Subnet Mask
xxx.xxx.xxx.x
xx
Input the subnet mask. Displayed when [IP
Address Set] is set to [Manual].
Gateway Address
xxx.xxx.xxx.x
xx
Input the gateway address. Displayed when
[IP Address Set] is set to [Manual].
DHCPv6
Disable
Set to obtain the IPv6 address
automatically. Set to [Disable] when you do
not use the IPv6 address.
HUB Link Setting
Auto
Negotiate
Sets the connection method to the hub.
System
Adjust
Power Save Time (Fn200)
1minute
Sets the time that will elapse before the
power save mode is entered.
Value range: 1 minute, 2 minutes, 3
minutes, 4 minutes, 5 minutes, 10 minutes,
15 minutes, 30 minutes, 60 minutes
Sleep Time (Fn200)
15minute
Sets the time that will elapse before the
sleep mode is switched from the power save
mode.
Value range: 1 minute, 2 minutes, 3
minutes, 4 minutes, 5 minutes, 10 minutes,
15 minutes, 30 minutes, 60 minutes
Auto Power Off Time (Fn202)
4hours
Sets the time that will elapse before the
power is turned off automatically after the
standby mode is entered.
Value range: 1 hour, 2 hours, 3 hours, 4
hours, 8 hours, 12 hours, 18 hours, 24
hours
Silent Mode
On
Specifies the printing preparations when the
standby mode is switched from the sleep
mode.
[On]: Silent due to no preparation for
printing.
[Off]: The image drum makes a noise as it
prepares for printing, facilitating a faster
speed for the first printing start time.
Clearable Warning
ONLINE
Sets the timing to clear the recoverable
error display.
Auto Continue
Off
Sets whether or not to automatically restore
this machine when a memory overflow or
tray request occurs.
Manual Timeout
60seconds
Sets the waiting time for loading the paper
when you print with [Feed paper individually]
checked in the printer driver.
Value range: Off, 30 seconds, 60 seconds