Sets the time from loss of the data receipt
(canceled by PostScript) until force-printing.
Value range: Off, 5 seconds, 10 seconds,
20 seconds, 30 seconds, 40 seconds, 50
seconds, 60 seconds, 90 seconds, 120
seconds, 150 seconds, 180 seconds, 210
seconds, 240 seconds, 270 seconds, 300
Seconds
Sets the time to keep each port open after
printing. (Except for network)
The value range is from 0 to 300 seconds in
increments of 5 seconds.
Sets the time to keep the network port open
after printing.
The value range is from 0 to 300 seconds in
increments of 5 seconds.
Sets the action of this machine when "Toner
Low" is displayed.
This machine goes offline when [Stop] is
selected.
Print Mode w/o Color Toner
Specifies the action when there is an empty
color toner cartridge.
[Alarm]: This machine stops without printing
the color print data.
Replace the empty toner cartridge with a
new one.
[Cancel]: Cancels color print data
automatically.
Replace the empty toner cartridge with a
new one.
Sets whether to reprint pages not printed
due to a paper jam after the paper jam is
cleared.
When [Off] is selected, the printing process
including pages missed due to the paper
jam will be canceled.
Sets whether to print an error report when
an internal error occurs.
Prints the data received from the PC in
hexadecimal dump. To exit this mode, turn
off the power.
Sets the size of the paper you want to print
on from the MP tray.
210
millimeter or
8.5 inch
*2
Sets the paper width when you have
selected a custom size for the paper that
you want to print on from the MP tray.
297
millimeter or
11.0 inch
*2
Sets the paper width when you have
selected a custom size for the paper that
you want to print on from the MP tray.
To Next Page
Loading...
