Input the IPv4 address manually.
Displayed when [IP Address Set] is set to [Manual].
Input the subnet mask.
Displayed when [IP Address Set] is set to [Manual].
Input the gateway address.
Displayed when [IP Address Set] is set to [Manual].
Set to obtain the IPv6 address automatically. Set to disable
when you do not use the IPv6 address.
Executed when setting is done by pressing the WPS button
of the wireless LAN access point.
Executed when the PIN code displayed on this machine is
registered with the wireless LAN access point.
Wireless
Network
Selection
Displays the list of wireless LAN access points detected by
this machine.
Sets the security of the wireless LAN function.
Displays the WPA-PSK encryption type.
The setting is carried out automatically according to the
security settings. (Impossible to switch in this menu)
Input the pre-shared key.
Displayed when [Security] is set to any other value than
[Disable] or [WEP].
Executes the changes to security settings.
Reconnects to the wireless LAN (infrastructure).
Wireless(AP Mode) Setting
Input the password required to enter the Admin Setup
menu.
Enables/Disables wired (AP mode).
Automatic Setup (PushButton)
If YES is selected, automatic connection can be started
with a push button.
If the connection has failed, the system goes back to the
home screen. If the connection is successful, [Wireless(AP
Mode) connection setting is completed/Close by the setting
button] is displayed.
Displays the SSID and password of this machine for
manual setup.
Printronix-
Printer name-
Last 6 digits
of the MAC
address
Inputs a new one to change the SSID.
Inputs a new one to change the password.
Executes connection setup.
Sets whether or not to disclose the AP mode information to
users other than the administrator.
To Next Page
Loading...
