Printronix LP654C - Page 128

- 129 -
Item
Factory
default
settings
Description
Auto Density Mode
Standard
Sets whether to automatically adjust the density/tone for
color printing. Or, changes the frequency to adjust the
density/tone for color printing.
Adjust Density (Fn300)
Execute
Executed when you want to adjust the density immediately.
Adjust Registration (Fn301)
Execute
Executed when you want to adjust the registration
immediately.
Long Paper Adjust
0
Adjusts the fixing speed for printing on long paper.
Set to a plus value if color shift occurs, or to a minus value
if color misregistration occurs.
Color Density
Cyan Density
(Fn310)
0
Sets the print density for each color. Adjusts within the
range of ±3. Darkens the print result by adjusting in +
direction, or lightens the print result by adjusting in -
direction.
Magenta Density
(Fn311)
0
Yellow Density
(Fn312)
0
Black Density
(Fn313)
0
Print Color Tuning Pattern (Fn302)
Execute
Prints a pattern for density adjustment.
Cyan Tuning
Highlight
0
Adjusts the density of highlights (light areas), mid-tone and
dark tone (dark areas) for each color. Darkens the density
by adjusting in the plus direction, and lightens the density
by adjusting in the minus direction.
Used for fine adjustment that is not possible with the
density setting. Adjusts within the range of ±3.
Mid-Tone
0
Dark
0
Magenta Tuning
Highlight
0
Mid-Tone
0
Dark
0
Yellow Tuning
Highlight
0
Mid-Tone
0
Dark
0
Black Tuning
Highlight
0
Mid-Tone
0
Dark
0
AirPrint
Item
Factory default settings
Description
AirPrint
Enable
Sets AirPrint to [Enable].
Wireless(Infrastructure) Setting
Item
Factory
default
settings
Description
Enter Password
**********
Input the password required to enter the Admin Setup
menu.
Wireless(Infrastructure)
Disable
Enables/Disables the wireless LAN (infrastructure).
Network
Setting
IP Address Set
Auto
Set to obtain the IPv4 address automatically or input it
manually.