ProntoNet
What’s New
7
F
ProntoNet ProntoNet IP Decoder PortaNet Nereus
Scheduler
A problem when modifying existing entries in the scheduler table has been fixed.
F
ProntoNet ProntoNet IP Decoder PortaNet Nereus
Connection recovery
From this version onwards, if the unit is switched off when the line was ‘down’ but came from a
‘connected’ status, the unit will try to establish the connection automatically upon restarting.
F
ProntoNet ProntoNet IP Decoder PortaNet Nereus
Net configuration recovery after scheduled call
Now, the type of network currently configured will be restored after the execution of a scheduled call.
N
ProntoNet ProntoNet IP Decoder PortaNet Nereus
Upgrading over WAN networks
The upgrading process has been enhanced in order to allow firmware to be upgraded over any IP
network, be it LAN or WAN.
N
ProntoNet ProntoNet IP Decoder PortaNet Nereus
New streaming protocol: Proprietary v2
With this new protocol it is possible to obtain network related parameters such as jitter, lost or
disordered packets in real time during the audio connection. To be able to get all this information,
Proprietaty Protocol V2 should be configured as audio protocol. This protocol is not compatible with the
previous one (version 1). Propreitary protocol version 1 will allow the user to get information about jitter
and buffer usage, but will not allow the user to obtain information about lost and disordered packets.
This information will be saved separately for each connection in RAM memory. Up to 24 hours of data
can be stored.
Once the connection is established, the user can access the ‘real time network analyzer’ by clicking on
the ‘buffer occupation graph’, in order to get information related to:
-Rx occupation: With average, maximum and minimum usage. Very low percentage of buffer
occupation will cause audio interruptions and drop-outs.
-Jitter: High jitter values will match with low buffer occupation.
-Lost and disordered packets.
To Next Page
Loading...
