Prodys ProntoNet - IV.6 CONF: General Configuration Menu; IV.6.1 Conf - Aud; IV.6.1.1. Aes;Ebu

Prontonet User’s Manual v410 42
CONF MENU
{AUD}PORTS SYS BOOK
CONF AES/EBU SYNC
{AUDIO} EXT
CONF AUDIO IN>>
{ANALOG} AES/EBU
<< CONF AUDIO IN
{AES/EBU TRANSP}
IV.6 CONF: General configuration Menu
Grouped here are all the general parameters. These are usually configured
during installation it is not normally necessary to reconfigure afterwards. They
are grouped in the following way:
 AUD: This selects between the analog and digital audio inputs.
 PORTS: From here you can configure the LAN, ISDN, X21 and RS232
ports.
 SYS: Here you can enable an Encoder/Decoder loop or configure
special modes such as the selection of an external clock when the
NET= IP.
 BOOK: For editing and saving entries in the Address Book.
IV.6.1 CONF – AUD:
From here select the audio input (analog or digital). If it is digital we can choose
between synchronising with the audio input or with an external clock:
IV.6.1.1. AES/EBU
If we select AES/EBU next we will see a screen where it will be possible to select
the sync type – internal (with the digital audio input) or external (coming from
another device connected to the AES/EBU connector).