Prodys ProntoNet - About How the Decoder Works and Automatic Searching

Prontonet User’s Manual v410 91
V.7 About how the Decoder works and automatic searching
The ProntoNet Decoder system doesn’t need to be configured as it is totally
automatic. However, it is necessary to point out some aspects of how it works as
it depends on the format of incoming data. The ProntoNet is able to synchronise
automatically to the following algorithms under the following conditions:
Algorithm
IP Codec
(NET = IP)
ISDN Codec
(NET = ISDN)
X21 Codec
(NET = X21)
YES
YES NO
G711
Only when the
communication is
between two
ProntoNet units.
The system detects
incoming calls such as
voice calls and
configures the Encoder
and Decoder to G711.
Algorithm not available.
YES YES YES
G722
Only when the
communication is
between two
ProntoNet units.
Needs G722 encoded
audio since it is
synchronised by means
of statistical framework.
It does not work if
encoder is
configured to aptX.
Needs G722 encoded
audio since it is
synchronised by means
of statistical framework.
It does not work if
encoder is
configured to aptX.
YES YES YES
MPEG1,2 LII
MPEG1,2 LIII
MPEG2,4 AAC LC
MPEG 4 AAC LD
Only when the
communication is
between two
ProntoNet units.
Detects all modes
excepts if the Encoder
is configured to aptX.
It does not work if
encoder is
configured to aptX.
Detects all modes
excepts if the Encoder
is configured to aptX.
It does not work if
encoder is
configured to aptX.
YES NO NO
aptX
TM
Only when the
communication is
between two
ProntoNet units.
It is necessary that the
Encoder is also
configured to aptX.
It is necessary that the
Encoder is also
configured to aptX.
YES NO NO
PCM
Linear Audio
Only when the
communication is
between two
ProntoNet units.
Not Available. Not Available.