Prodys ProntoNet - III.2.2.3. Screen 3: Decoding Algorithm; III.2.2.4. Screen 4: Encoding Algorithm

Prontonet User’s Manual v410 26
D1:MPL2-64-ST-48
D2:NOT AVAILABLE
E1:MPL2-64-MN-48-CR
E2:G722
III.2.2.3. Screen 3: Decoding algorithm
This window shows the algorithm that is selected and synchronised for Decoder
1 and 2 (number 2 is only relevant when ProntoNet is working as a DUAL codec).
Here are some examples:
.
If the Decoder is not synchronised it will show the text “SEARCHING”
The different algorithms are written in the following way:
 PCM – Mode - Fs – number of bits.
 G711 – Law.
 G722.
 MPEG Layer II – Bit rate – Mode – Fs – CRC.
 MPEG Layer III – Bit rate – Mode – Fs – CRC.
 AAC MPEG2 LC – Mode – Fs – CRC.
 AAC MPEG4 LC – Mode – Fs – CRC.
 AAC MPEG4 LD – Mode – Fs – CRC.
 aptX – Mode.
III.2.2.4. Screen 4: encoding algorithm
This is similar to the Decoder described above, but will describe the encoding
algorithm instead.
The different algorithms are displayed in the same way as the Decoder outlined
above, except for the following modes:
 AAC MPEG2 LC – Bit rate – Mode – Fs – CRC.
 AAC MPEG4 LC – Bit rate – Mode – Fs – CRC.
 AAC MPEG4 LD – Bit rate – Mode – Fs – CRC.
D1:MPL2-064-MN-48
D2:G722