ProntoNet
What’s New
14
Date 12-1-07
Version v4.8.1
N ProntoNet ProntoNet IP Decoder PortaNet Nereus
User configurable TCP/UDP ports
It is possible to configure which ports the unit will use for its TCP/UDP communications.
N ProntoNet ProntoNet IP Decoder PortaNet Nereus
DNS support
By specifying the IP address of a DNS Server, the user can make calls to ‘names’ instead of IP
addresses.
N ProntoNet ProntoNet IP Decoder PortaNet Nereus
GPIO monitoring
The GPIO status information is displayed in the ‘system’ information box of the web page.
N ProntoNet ProntoNet IP Decoder PortaNet Nereus
User configurable Web Page time-out
When entering the Web Page, the user can set the time-out period for the connection between the PC
running the web browser and the unit.
By default, this period is set to 5 seconds.
The user should take into account that the longer the time-out, the less likely it is that the connection
between the PC and the unit will be lost.
N ProntoNet ProntoNet IP Decoder PortaNet Nereus
Encoder mode restoration when the line drops
The audio compression mode is restored to that one prior to the connection.
This allows the user to change the compression mode during the connection, or to make calls through
the book entries with compression modes different from the former one.
N ProntoNet ProntoNet IP Decoder PortaNet Nereus
New IP channel for auxiliary data
So far, the auxiliary data over IP was sent along with the audio, in the same way as with ISDN and
X21.
From this version on, when selecting IP as communication interface, the auxiliary data will be sent on
a different path, different from the audio one. This method has 3 big advantages: less delay
independent from the audio codification delay; the possibility to send/receive auxiliary data regardless
of the compression mode used for the audio communication; and the possibility to send/receive the
User bit of the AES/EBU frame.
N ProntoNet ProntoNet IP Decoder PortaNet Nereus
To Next Page
Loading...
