Prontonet User’s Manual v410 44
SET ADDRESS LAN
. . . .
SET SUBMASK LAN
. . . .
SET GATEWAY LAN
. . . .
LAN CONFIG
{IP}DHCP
LAN CONFIG
{IP}DHCP
SET INT ADDRESS
. . . .
The different screens for the configuration of these parameters are as follows:
DHCP
By setting DHCP, the unit will receive its IP parameters when starting. These IP
settings might be different from time to time, that is why ProntoNet supports
RIP2 protocol. This protocol allows to set an ‘internal’ IP address, in order that
the unit can be identified regardless of the IP settings provided by the DHCP
server.
O
O
O
O
To Next Page
Loading...
