Prodys ProntoNet - Page 63

Prontonet User’s Manual v410 63
OUTPUTS
Transparent Under this configuration, the state of the output will be the same
that its homologous input has in the ProntoNet connected in the
other end.
Line 1 Connected The output will be activated when the line 1 is connected.
Line 1 Disconnected The output will be activated when the line 1 is disconnected.
Line 2 Connected The output will be activated when the line 2 is connected. It
makes sense only when the ProntoNet is working in ISDN mode
as a DUAL CODEC.
Line 2 Disconnected The output will be activated when the line 2 is disconnected. It
makes sense only when the ProntoNet is working in ISDN mode
as a DUAL CODEC.
Decoder 1 Framed The output will be activated when the Decoder 1 is Framed.
Decoder 1 NOT framed The output will be activated when the Decoder 1 is NOT Framed.
Decoder 2 Framed The output will be activated when the Decoder 2 is Framed. It
makes sense only when the ProntoNet is working in ISDN mode
as a DUAL CODEC.
Decoder 2 NOT framed The output will be activated when the Decoder 2 is NOT Framed.
It makes sense only when the ProntoNet is working in ISDN
mode as a DUAL CODEC.
Backup Active The output will be activated when the ISDN Backup is working.
Backup NOT Active The output will be activated when the ISDN Backup is NOT
working.
Alarm Active The output will be activated when one Alarm is activated.
Alarm NOT Active
T
he output will be activated when there are NOT Alarms
activated.
 Transparent configuration only works with audio algorithms that support
ancillary data and have been previously activated.
When a GPO is configured to monitor alarms (“Alarm active”), It is posible to
select which alarms will enable this output.