PROEMION CANlink wireless 3002 - Page 96

Device Manual CANlink wireless
Operation
PROEMION GmbH | Phone: +49 661 9490-600 | Fax: +49 661 9490-666 | info@proemion.com | proemion.com | Version 1.0 91
© 2016RM MICHAELIDES● VX.X ● Device Manual CANlink 5000 series © 2016RM MICHAELIDES● VX.X ● Device Manual CANlink 5000 series © 2016 PROEMION GMBH > 1.0 EN > Device Manual CANlink wireless 3000 series
Device MENU Description
C
ONNECT
Create a connection to the CANlink wireless via the RS232
Interface.
If you execute this function when no configuration is open, the
configuration data is automatically read from the CANlink wireless.
Shortcut: Ctrl + shift + C
D
ISCONNECT
Disconnect the CANlink wireless. This closes the configuration
mode.
Shortcut: Ctrl + shift + D
R
EAD DATA FROM THE
DEVICE
Read the configuration from the connected CANlink wireless.
If you execute the function while a configuration is open, the open
configuration is overwritten.
Shortcut: Ctrl + shift + R
WRITE DATA TO THE
DEVICE
Transfer the current configuration to the connected
CANlink wireless.
Shortcut: Ctrl + shift + W
D
EVICE INFORMATION
…
Display information regarding the connected CANlink wireless
(device ID, product code, serial number, etc.). The function is
available after the device is connected.
Shortcut: Ctrl + shift + I
R
ESET DEVICE TO
FACTORY SETTINGS
Reset the connected CANlink wireless to the factory settings.
Device menu
Options menu Description
C
ONNECTION SETTINGS
Open the connection settings.
The software saves connection settings and loads them
automatically when started.
Options menu