1-7
ROTALIGN 01.2000
AVOID EXPOSURE
LASER LIGHT IS EMITTED
FROM THIS APERTURE
µ
λ
Laser safety
The ROTALIGN system uses a Ga-Al-As semiconductor laser, classi-
fied as a Class II laser. These lasers comply with the requirements
outlined in the USA's FDA specification 21 CFR Ch. 1, Parts 1040.10
and 1040.11 as well as the ANSI standard. ROTALIGN also fulfills
British standard BS 4803 (Part 1 to Part 3) and European Industrial
Standard IEC 825. The ROTALIGN Class II laser operates at a
wavelength of 675 nm, with a maximum pulse duration of
<400 µsec., maximum radiant power of <1 mW and maximum
radiant energy per pulse of 0.4 µJ. No maintenance is necessary to
keep this product in compliance with the above specifications.
Do not look into the laser beam at any time, including during
setup, adjustment or operation!* Risk of injury!
*Since the FDA specification allows maximum exposure of
0.25 seconds, the natural blink reaction of the human eye is
normally sufficient to avert any danger, provided that no optical
instruments other than ordinary eyeglasses or contact lenses are
used. Do not insert any other optical devices into the beam path.
Caution: use of controls or adjustment or performance of proce-
dures other than those specified herein or failure to follow these
instructions may result in hazardous radiation exposure.
The diagram below shows all locations of laser safety labels on the
ROTALIGN laser housing.
Safety and operating information
WARNING!
To Next Page
Loading...
Need help?
General
