5-11
ROTALIGN 01.2000
OPTION: Nonsymmetrical flange shape
OPTION: Nonsymmetrical flange shape
From the Vertical dimensioning screen you can select OPTION to set
up a nonsymmetrical flange:
Altering a rectangle or ellipse
Press option to change the overall flange dimensions:
Use the arrow key to highlight the Y-AXIS (front to back) or X-AXIS
(along the front) dimensions then press EDIT to change them.
Adjusting center position
Press ADJUST CENTER to move the central axis to a new position:
Use the arrow keys to move the center to a new location shown by the
X and Y coordinates, lower right. Press STEP SIZE to make the center
move inward: X-large (100"/1000mm), large (10"/100mm), medium
(1"/10mm) or small (0.1"/1mm) steps. The available steps depend on
the machine diameter you entered. The CLR key recenters. Press OK
when finished.
OPTION
ADJUST
CENTER
OK
To Next Page
Loading...
