1-6
ROTALIGN 01.2000
Safety information
The following information must be observed to ensure the safe
operation of the ROTALIGN.
General
• Before starting up the machines, all ROTALIGN components
must be removed from the shaft (or coupling). Otherwise,
serious bodily injury may result from flying parts!
• The device must not be operated with the housing open or
removed.
• The sensor, laser and computer housing must not be opened.
Water and dust seals cannot otherwise be guaranteed.
• The device must only be operated and serviced by trained
personnel.
• Repairs of the ROTALIGN system must only be carried out by
an authorized technician.
• Only original spare parts and accessories must be used.
• Any unauthorized modifications to the ROTALIGN, its com-
ponents and the operating procedures described herein shall
render all warranty coverage void.
Intrinsically safe version
ROTALIGN is also available in an intrinsically safe version which
fulfills the following specification: EEx ib IIC T4; approx. U.S.
equivalent: NEC Article 500-4, Class 1, Division 1, groups D,C,B,A
and special safeguards T4.
Please note that with this version, only alkali-manganese batteries or,
for the main battery, the ALI 3.572 rechargeable battery must be
used. Do not use lithium or NiCad batteries for the main battery
(MAIN BATT), for the auxiliary battery (AUX BATT) or for the laser
power supply!
• Risk of explosion! Batteries must not be changed in areas
where the risk of explosion exists.
ATTENTION
Safety and operating information
WARNING!
WARNING!
To Next Page
Loading...
Need help?
General
