6-36
ROTALIGN 01.2000
Warranty, service and care
Warranty, service and care
ROTALIGN is a precision measurement instrument which should be
handled as such. When not in use, it should always be stored in its
protective carrying case.
Warranty
The ROTALIGN laser diode is guaranteed for two years. All other
system components are covered by a one-year warranty. Please note
that any attempt to service the components by unauthorized person-
nel will render all warranty coverage void.
Service and care
Although the ROTALIGN system is essentially maintenance-free, the
following points should be observed: The calibration accuracy of the
system should be checked every two years as indicated by the colored
label (shown at left) located on the back of the receiver housing.
Please return ROTALIGN to your authorized PRÜFTECHNIK distribu-
tor for calibration checking.
All optical surfaces (laser aperture, receiver lens) must be kept clean.
Use the ALI 2.905 cleaning set or a fine dusting brush such as that
normally used to clean other optical devices; avoid vigorous polish-
ing to preserve the anti-reflective coatings of the glass elements. The
computer housing may be wiped clean using a soft cloth dampened
with a mild, nonabrasive detergent.
If any problems are encountered during use, consult the trouble-
shooting guide on page 6-11 for help in locating and correcting the
problem. If the problem still cannot be resolved, then contact your
PRÜFTECHNIK AG representative for further assistance.
Only original PRÜFTECHNIK replacement parts must be used.
12
11
10
9
8
7
6
5
4
3
2
1
98
To Next Page
Loading...
Need help?
General
