4-1
ROTALIGN 01.2000
Chapter 4: Horizontal Alignment
This chapter includes instructions for aligning horizontal machine
arrangements. A description of the Q
UICK CHECK alignment mode is
given first, followed by instructions for the more thorough standard
horizontal alignment mode.
Chapter 1 Introduction ................................. 1-1 to 1-10
Chapter 2 Description ...................................2-1 to 2-16
Chapter 3 Configuration and
Data Management ......................... 3-1 to 3-8
Chapter 4 Horizontal Alignment .................. 4-1 to 4-66
QuickCheck... ................................................................................ 4-3
Menu overview - horizontal machines........................................... 4-6
The Menu ...................................................................................... 4-7
Horizontal machine alignment flow chart ..................................... 4-8
Horizontal machine alignment ...................................................... 4-9
1. Prepare the machines ........................................................... 4-10
2. Mount the brackets ............................................................... 4-11
3. Mounting laser and receiver ................................................. 4-12
Connecting the receiver ........................................................ 4-13
4. Switch on the computer ....................................................... 4-14
Select horizontal alignment .................................................. 4-15
5. Machine dimensions ............................................................. 4-16
Machine setup....................................................................... 4-17
Coupling type ........................................................................... 4-19
Enter the dimensions ................................................................ 4-21
6. Laser beam adjustment......................................................... 4-23
XY VIEW ................................................................................... 4-25
TRACE .................................................................................. 4-26
Why centered AND perpendicular? .......................................... 4-27
7. Measurement ....................................................................... 4-28
Soft foot .................................................................................... 4-29
Select measurement mode........................................................ 4-33
CONTINUOUS SWEEP .......................................................... 4-34
MEASURE AT 0,3,6,9 ............................................................ 4-35
MULTIPOINT ........................................................................ 4-36
PASS MODE (UNCOUPLED) ................................................. 4-36
DIAL GAUGE VALUES ........................................................... 4-39
Chapter 4: Horizontal Alignment
To Next Page
