MP3-PL Therapy Beam Analyzer T41050
Use of the product without observing the user
manual.
Bodily Injury! Equipment Damage!
Always use the product in compliance with the
user manual. Otherwise, the intended protection
can be reduced.
Use the product only in conjunction with the
products approved for this purpose by PTW
and/or the products listed in the section "Intend-
ed Use".
Handle the product with care to avoid equipment
damage.
Operation under inadequate ambient conditions.
Equipment Damage!
Before connecting the device to the power line,
make sure that line voltage and frequency are
equivalent to the ratings indicated on the name-
plate of the device.
Set up the device in a location which affords
sufficient ventilation. The air gaps of the device
must not be obstructed.
Always observe the ambient conditions as indi-
cated in the `Technical Specifications`.
Operation in conjunction with particle beams.
Equipment Damage!
Continuous irradiation with a pencil beam
through the entrance window at a fixed position
can cause a local discoloring of the material. If
such a discoloring appears, the position of the
beam traversing the entrance window should be
shifted (e.g., laterally by 15 mm). Continued irra-
diation through the original position can lead to
radiation damage of the entrance window mate-
rial. Cracks can occur.
Improper handling of cables and connectors.
Equipment Damage!
To avoid damage to the cables and connectors,
observe the following points.
Do not kink the cables. Observe the minimum
bend radius of the cables. Never exert pres-
sure on the cables. Do not step on the cables.
Do not roll trolleys over the cables. Do not pull
or twist the cables.
Disconnect the cables from the devices during
transport and when the devices are not in
use. Do not let the cables hang down unre-
strained.
The connectors must always be clean. Do not
allow the connectors to lie on the floor. Al-
ways protect connectors when pulling them
through cable conduits.
To Next Page
Loading...
