• Keep fresh water in the water reservoir.
• Clean the Brush Assembly weekly with fresh water.
• Rinse out the sponge with fresh water weekly.
• Replace the brush assembly when the moistener is not moistening properly.
• Replace the sponge when it begins to break down and not soak up water properly.
To clean the brushes and sponge of the feed table moistener:
1. Remove the moistener assembly from the table.
2. Raise the brush.
3. Lift the metal sponge retainer to remove the sponge.
4. Clean the sponge and the brush.
5. Reinstall the sponge and retainer.
6. Put the brush back.
13
Troubleshooting
261
| Page 261 | Jun-21-2021 09:24 |
To Next Page
Loading...
Need help?
General
