How to Set [Pass Through] Mail processing
This section describes how to use the [Pass through] type of imprint, for:
• Only conveying mail, for counting or testing purposes.
Main setting:
1. Make sure you are on the home screen of the [Pass Through] type of imprint.
The type of imprint is indicated at the top of the home screen as illustrated.
2. Check or change the type of imprint, if you are not in [Pass through] mode.
Press to access the imprint screen:
To change the type of imprint, select the Type line, press [OK] and then select
[Pass Through] in the Type of imprint screen and press [OK].
To select an option in the screen:
- Highlight the option using the arrow keys and
- Then press to validate your selection.
3.
Press or to return to the home screen.
On the [Pass Through] home screen:
1.
Press . System motors start running.
48
| Page 48 | Jun-21-2021 09:24 |
3
Processing Mail