Raven DirecSteer - Status; Current Accuracy; Accuracy Threshold

Chapter6
2.
Select the GPS Setup tab.
3. Select the Position Accuracy Setup button.
The Position Accuracy page displays the following information:
Status
Displays the status of the GPS/GNSS solution. Statuses that may be displayed in this area
include:
l
No Signal
l
Error
l
Converging
l
Converged
Current Accuracy
Value displayed is the horizontal standard deviation reported by the GPS/GNSS receiver.
Accuracy Threshold
This user-defined value sets the allowable deviation from current machine GPS position. If
the GPS solution falls outside the set threshold, a DTC will be triggered. The default Accuracy
Threshold value is 254 cm [100 in].
102