Certification and Compliance
Roadway Homologation
The Accept Roadway Homologation Terms page will be displayed during the initial calibration
of the RS1™ system in either of the following conditions:
l
Operating with a generic tune-set
l
Operating on the European continent
Carefully review the on-screen disclaimer before proceeding.
When roadway homologation is enabled, the following parameters will be applied to RS1™
operation:
l
An operator presence method will be required while operating with the RS1™ auto-
steering system enabled.
l
Auto-steering cannot be enabled above 19 mph [30.5 km/h].
l
Auto-steering will disengage above 21 mph [33.8 km/h].
203
Chapter 8:
Certification and Compliance
To Next Page
Loading...
