External Device Settings
20. Verify that “NEMA” out and TSIP out are set to ASAP.
21. Press the Enter button to save the settings.
22. Press the Down button until “CFG: NEMA QUALITY” displays.
23. Verify the setting is Report True Mode.
24. Press the Enter button to save the settings.
Port B Configuration
1. Press the Right button until “Configuration” displays.
2. Press the Down button to select “Configuration”.
3. Press the Right button until “Port B Config” displays.
4. Press the Down button to select Port B Config.
5. Verify the Input (I) messages are set to TSIP and the baud rate is set to 115K.
51
To Next Page
Loading...
