System Settings
3. Select the Machine Offsets Setup button.
Help Menu Icon
Note: Select the Help Menu icon to access the Help Menu. The Help Menu may contain
additional information about the features and options displayed on the page.
Antenna Height
The Antenna Height is calculated by measuring from the ground to the center of the GNSS
antenna.
Antenna Center Offset
The Antenna Center Offset position is calculated by measuring from the center of the
machine to the center of the GNSS antenna. Enter a negative value if the GNSS unit is
located to the left of the machine center line.
Antenna Fore/Aft
The Antenna Fore/Aft position is calculated by measuring from the rear axle of the machine
to the middle of the GNSS antenna. Enter a negative value if the GNSS antenna is located
behind the rear axle.
73
To Next Page
Loading...
