Raven DirecSteer - Resume;Disengage Calibration

Chapter3
5. The Status icon displays the current state of the sensor.
l
Presence sensor is disconnected. Connect the sensor to the system before
proceeding.
l
Presence sensor does not detect an operator.
l
Presence sensor detects that the operator is present.
Resume/Disengage Calibration
1. Test the resume button or foot switch.
a. Press and release the resume or foot switch. The switch status icon on the page
will change if the switch input is detected and the calibration will automatically
proceed to the next page.
b. If a foot switch is not available, or if the on-screen widget will be used, select the
Use On-Screen Engage button. The calibration will automatically advance to the
next page.
2. Select the Next page button to proceed.
34