Diagnostics and Troubleshooting
6. Select the center Up arrow button. Wait for the actuator to reach the center position.
7. Select the Left arrow button. Wait for the actuator to reach the left position and for
information to populate each field displayed on the page.
8. Continue to drive forward at a speed between 1.6 - 6.4 km/h [1 - 4 mph] with the
engine RPM set at approximately 3/4 throttle.
9. Select the center Up arrow button. Wait for the actuator to reach the center position.
10. Select the Right arrow button. Wait for the actuator to reach the right position and for
information to populate each field displayed on the page.
11. To test consistency of the auto-steer system, repeat the procedure and check values
against previous test results.
Note: Once the Step Response Test has been completed, the machine performance reading
should fall within the recommended system settings. Provide the collected data to a Raven
Technical Service team to verify that machine performance falls within the recommended
settings.
Machine Test
Note: Some pages and options may differ based upon how the machine or implement is
configured.
Machine Steering
1.
From the auto-steer home page Home page select the Diagnostic icon.
181
To Next Page
Loading...
