System Settings
Steering Control Calibration
The steering control calibration process allows the auto-steering system to learn the
hydraulic or mechanical capabilities of the machine for optimal steering performance in the
field.
Note: When operating with a generic tuneset, the steering control calibration must be
performed to tune the auto-steer system to the machine. The Quick Calibration option is not
available when the machine make and model selections were set to the "Generic" option at
the beginning of the calibration wizard.
Note: When operating with a specific make and model tuneset, the steering control
calibration is recommended to tune the auto-steer system to the specific machine. However,
when a make and model tuneset set selected at the beginning of the calibration wizard, the
control calibration process can be bypassed with the Use Quick Calibration option. This
allows the system to load the predefined gains for the selected machine profile.
Preparation
Before beginning the machine steering system calibration, ensure that the following
conditions are met:
l
The booms are racked on self-propelled units.
l
There are no implements connected to the hitch.
l
The machine engine is running at the normal operating RPM.
83
To Next Page
Loading...
