Raven DirecSteer - Baud Rate; Message Types

System Settings
GPSOut
Provides 3D compensated GNSS position messages in a NMEA0183 format through the
serial output.
Baud Rate
The rate at which messages are transmitted over the serial port. This rate must be set to
match the devices on the system which are intended to receive serial output messages.
Note: The default baud rate setting is 115200 and is recommended for auto-steering
systems.
Message Types
Allows the operator to configure required and desired NMEAmessage types and frequency.
Note: Changing message types and rates may cause poor system performance. It is not
recommended to change message rates unless instructed by documentation or the Raven
Technical Service team.
Radio Modem
Configure a radio modem for serial output.
107