Machine Calibration
NOTICE
Installation of the system must be fully completed before
calibrating the system. Refer to the machine-specific installation
manual or contact your local Raven dealer for assistance with
installing the system.
A profile wizard starts automatically and must be completed the first time which the steering
module is accessed after installation or any time the ECU is reset.
Refer to "Reset Calibrated Gains" on page93 for additional information about resetting the
steering system.
Note: System Information, Diagnostic Trouble Codes (DTCs), and Machine Test screens may
be viewed during the initial calibration process. Refer to the following topics for additional
assistance with the settings available during the initial calibration wizard.
l
"SGC System Information" on page194
l
"Diagnostic Trouble Codes (DTCs)" on page145
15
Chapter 3:
Machine Calibration
To Next Page
Loading...
