Machine Calibration
Guidance and GNSS Calibration
Note: The following steps are intended to outline the calibration procedure. Some options
shown will be dependent upon settings and options selected.
1. Open the UT menu of the display or field computer.
2. During the initial start-up of system, the operator will be presented with the Operator
Liability prompt.
Note: Refer to the "Operator Liability" on page53 topic for more information.
3.
Select the guidance and steering working set icon .
Note: The Slingshot® working set icon only displays with an RS1™.
4. Confirm that the correct ECU will be programmed by selecting the Information icon in
the upper, right corner and matching the Hardware Serial Number to the ECU serial
number mounted to the machine or implement.
Note: If the Machine Home page displays, the ECU is calibrated already for that
terminal. Check other terminals for an ECU that has not been calibrated.
19
To Next Page
Loading...
