7
Manual No. 016-0171-148 133
Tools Menu
Section Setup
1. On the Section Configuration screen, touch the Next icon to begin configuring sections.
The Number of Sections screen is displayed.
2. Use the Up and Down arrow buttons to setup the number of sections for the vehicle or implement. Touch
the Next icon to proceed to the Section Width screen.
Note: To utilize AccuBoom, automatic boom section control, plumbing on the vehicle or implement must
allow for individual section control. If the equipment is not capable of controlling individual
sections, set the number of sections to 1 and enter the overall boom or implement width on the
Section Width screen.
To Next Page
Loading...
