6
Manual No. 016-0171-148 59
Basic Operation
Direction of Travel
The last direction of travel detected by the field computer is displayed on the Start Job - Verify Settings screen.
If the direction of travel indicator displays incorrectly, touch the indicator to manually toggle the last detected
GPS direction.
Note: The direction of travel indicator is also displayed on the GPS Health screen and may be toggled
during a job if necessary.
Refer to the Reverse Sensing section on page 115 for more information or to enable the direction
of travel indicator.
The direction of travel indicator will not be displayed if a SmarTrax 3D node is detected on the
CANbus and the terrain compensation feature is active.
Job File Setup
Select the Job button to select an existing job file or rename the new job.
Note: Renaming new job files is highly recommended if a specific job will be referenced at a later date.
The operator should enter field location, product or any other information which may help identify
specific job files. Names of job files entered on the field computer cannot begin or end with a
space.
To Next Page
Loading...
Need help?
General
