Manual No. 016-0171-122 Rev. I 255
Flow Meter/Encoder Extension Cables
Before starting this test, disconnect the flow meter cable from the flow meter. Hold the flow meter cable so that
the keyway is pointing in the 12 o’clock position as shown below.
FIGURE 2. Flow Meter Extension Cable Pin Diagram
Note: In a non-CAN system if a +5 voltage reading is not present, disconnect the Speed Sensor cable. If
the voltage reading is restored, test the Speed Sensor cable as described in Appendix G, Testing
the Speed Sensor Extension Cable.
Testing the Flow Meter/Encoder Cable
1. Touch Product Control.
2. Touch the Product Control Settings area.
The CAN Controller Status screen will be displayed.
3. Touch within the Product Control Settings area to display the node settings screen for the selected control
channel.
10 o’clock
Power
2 o’clock
Ground
Keyway
6 o’clock
Signal
5 VDC
5 VDC
To Next Page
Loading...
