Advancing to the next waypoint in a route
You can skip the current active waypoint and advance to the next
waypoint in a route at any time.
While following a route in the chart application:
1. Press the GOTO softkey, or position the cursor over the route.
2. Press the ADVANCE WAYPOINT softkey.
Note: If the current destination is the last waypoint, the chart
advances on to the rst waypoint in the route.
Following a route in reverse order
In the chart application:
1. Select the NAVIGATION softkey.
2. Select the FOLLOW ROUTE OPTIONS softkey.
The Route List is displayed.
3. Select the route you want to follow.
4. Select the REVERSE AND FOLLOW softkey.
Note: You can stop following a route at any time by selecting
the STOP FOLLOW softkey.
Cross Track Error (XTE)
Cross Track Error (XTE) is the amount of deviation from your
intended route or waypoint, expressed as a distance.
In the event that you steer off-track, you can go straight to your
target by resetting XTE.
Resetting Cross Track Error (XTE)
While following a route in the chart application:
1. Press the RESTART XTE softkey.
Resetting XTE results in a new course from the current vessel
position to the current target waypoint. This does not affect your
saved route.
Erasing a route
In the chart application:
1. Select the PLANNING softkey.
2. Select the MY ROUTES softkey.
3. Highlight the required route from the list.
4. Select the ERASE ROUTE softkey.
5. Select YES to conrm the action, or NO to cancel.
Note: You can delete any route, except for the one that you are
currently following. When you erase a route, only those waypoints
associated with that route are deleted.
64 E-Series Widescreen User reference
To Next Page
Loading...
