V 01/2016
4 General Safety Information RT100 Control System
extinguisher must be provided by the operator, taking into account the
equipment located in the room and the mandatory safety regulations.
The temperature control unit may only be operated when all safety sys-
tems are completely installed and intact.
The temperature control unit must be protected against sprays and clean-
ing agents.
Before detaching connecting lines in the temperature control circuit and
depending on the outlet temperature, allow the temperature control de-
vice to cool down first and then turn it off. Check that the pump is no
longer running.
WARNING
Important - danger of injury in the event of escaping water or oil!
Using this Documentation
This documentation contains important information for safe, economical
operation and for proper maintenance of the device.
Compliance with this documentation helps to avoid danger, minimise re-
pair costs and downtime, and increase the dependability and service life
of the device/system.
NOTE
The operating instructions should be kept near the corresponding de-
vice/system and always be accessible to operating and maintenance personnel.
Additional Documentation
The included instructions are completely correct for the basic versions of
devices. Components that do not belong to the basic hardware are noted
in the instructions as extra equipment. The corresponding additional doc-
uments are included with special versions of devices. Any additional doc-
uments supplement and/or replace the descriptions contained in these
instructions, which are then either invalid or only conditionally valid.
To Next Page
Loading...