V 01/2016
10 Design and Function RT100 Control System
Operation with Code/Password
In order to prevent the values that have been set or programmed from
being set again unintentionally, the use of a code/password is earnestly
recommended.
The RT100 Control System has three password levels that are organised
hierarchically:
User password - Default 0000 (switched off)
Technician password - Default 0100
Service password - only for personnel trained by Regloplas
NOTE
It is earnestly recommended that an operator password should be set up when
commissioning the temperature control device.
Operation with Timer
The RT100 Control System has an integrated real-time clock. If the op-
tion Timer is present, the device can be switched on and off with this op-
tion.
Alarm Reset and Alarm History
Alarm Reset
If an alarm has been triggered, the signal horn can be switched off by
pressing the Alarm Reset button. After the malfunction has been recti-
fied, the alarm can be reset by once again pressing the Alarm Reset but-
ton.
The Alarm Reset button also allows the manual acknowledgement of the
automatic toggling from control of the consumer temperature Sn2 to con-
trol of the outlet temperature Sn1 in case of a faulty or removed sensor
Sn2 in the consumer.
Alarm History
If there is no alarm pending, the Alarm Reset button can be used to view
the alarm history.
Save/Reset of the Setting Values
The RT100 Control System provides the facility to load the factory setting
values or the user settings at any time in a simple manner. Two different
customer-specific settings can be loaded afresh (user setting 1 and 2).
To Next Page
Loading...