V 01/2016
38 Parameterisation RT100 Control System
Options
The RT100 Control System options are displayed in this menu.
The RT100 Control System offers a releasing facility of software and
hardware options for function enhancement. The software options are re-
leased through a USB stick.
Parameter Range Remarks
Hardware options
Analog option
Installed hardware options are displayed. To
remove an option, it should be manually set
to OFF
Digital option
Option current monit. heating
Option reversal of rotation
Option Profibus
Option CANOpen
Option CAN Demag
Option Profinet
Option Ethernet/IP
Option Flow
Software options
Universal interface
Activated software options are displayed. For
releasing a software option, a code is re-
quired (file on USB stick). The serial number
of the control system is required for this pur-
pose
Switch clock
Ramp program
Cascade inlet
Flow rate measurement F150
Flow rate measurement F351
Flow rate measurement F1000
Reversal of direction of rota-
tion/suction
Pump regulation
Flushing
Flow deviation
Set-point ramps
USB Logging
Activate options Wait for USB stick
Detection of the USB stick, load software op-
tions from the USB stick. The serial number
of the control system is required for this pur-
pose
Serial number
Display of the base module serial number of the RT100 Control System
(8 letters, e.g. AALARP)
To Next Page
Loading...