V 01/2016
RT100 Control System General Safety Information 3
Information for Operators and Personnel
The operator and all persons who are tasked with working on the tem-
perature control unit must obey the fundamental regulations regarding
work safety and accident prevention. The operator must ensure that only
persons who have read and understood these operating instructions, par-
ticularly the chapter on safety, work on the temperature control unit.
Any working methods that have a negative effect on the technical safety
of the temperature control unit must not be used. The operator must en-
sure that the temperature control unit is operated only in flawless condi-
tion. If necessary, the company using the equipment must obligate the
operating personnel to wear protective clothing.
For all tasks having to do with set-up, start-up, operating, modification of
operating conditions and operational modes, maintenance, inspection
and repair, any shut-down procedures stated to be necessary in the op-
erating instructions must be followed.
Changing the Parameterisation
The parameterisation of the control system may only be carried out by
personnel trained by Regloplas. In particular, no parameters in the device
configuration may be changed without consulting Regloplas.
The relevant accident prevention regulations and the generally accepted
principles of safety engineering, occupational medicine and structural en-
gineering must be observed. The national safety regulations must also be
obeyed.
Residual Risks
Any unauthorised modifications and changes to the temperature control
device as also unauthorised changes to the parameterisation of the con-
trol system are prohibited for reasons of safety.
If the temperature control unit is damaged, it must not remain in use; the
defective part must be replaced or repaired immediately. Only original
Regloplas replacement parts may be used. Damage due to use of third-
party parts voids any and all warranty claims.
DANGER
The temperature control unit must be disconnected before it is opened (unplug
mains plug or, if present, turn the yellow/red main switch on the temperature
control unit)! Danger due to electrical shock!
Repair leaks in the temperature control circuit (device, connecting lines,
consumers, etc.) immediately.
In temperature control units that use oil as a heat transfer medium, it
should be noted that oil is flammable under certain conditions. For this
reason, the temperature control unit must not be located in the vicinity of
heat sources. The thermal insulation in the device must always be kept
clean. Insulation that is soaked with thermal oil poses an increased risk of
fire.
Burning thermal oil can be extinguished using a spray foam fire extin-
guisher, a powder fire extinguisher (avoid with dust-sensitive plants, con-
trol systems, EDP, etc.) or a CO
2
fire extinguisher. The appropriate fire
To Next Page
Loading...