REGLOPLAS RT100 - Page 42

V 01/2016
36  Parameterisation RT100 Control System
 Software version incompatible:
Analog Option, Digital Option, Heating current monitoring, Re-
versal of direction of rotation, Profibus, Profinet, Ethernet/IP,
CAN Demag, CANopen
 Option missing or faulty:
Analog Option, Digital Option, Heating current monitoring, Re-
versal of direction of rotation, Profibus, Profinet, Ethernet/IP,
CAN Demag, CANopen
 AD converter failure
 Attention - temperature control cabinet too high
 Turn on time refill exceeded
 Maximal operating time boost pump exceeded
 Min. pump pressure underrun
 Max. temperature exceeded Sn3
 Max. temperature exceeded Sn2
 Max. temperature exceeded
 Heating thermostat is activated
 Frequency converter alarm
 Motor current underrun
 Phase sequence failure
 Phase sequence unidentified
 Phase missing
 Motor contactor malfunction
 Temperature sensor Sn1 failure
 Temperature sensor Sn2 failure - switched to outlet control
 Temperature sensor Sn3 failure
 System pressure sensor inactive
 System pressure sensor failure
 Power failure
 Safety thermostat is activated
 Deviation set-point value/outlet exceeded
Deviation set-point value/outlet underrun
Deviation set-point value/external exceeded
Deviation set-point value/external underrun
Deviation set-point value/inlet exceeded
Deviation set-point value/inlet underrun
Deviation outlet/inlet underrun
Deviation outlet/inlet underrun