V 01/2016
60 Fault Rectification RT100 Control System
Error message Rectification
lost the front panel
USB Slave mode operation not possible Switch on the temperature control unit again
Save/Load not possible in USB Slave Mode Switch on the temperature control unit again
Save/Load not possible during device is on Switch the temperature control unit to OFF
Switch over heat carrier - reboot of the machine re-
quired
Switch on the temperature control unit again with the
main switch
Error, password not reset Enter the reset code correctly
Password reset Passwort was reset
Illegal operation Observe the operating sequence
Zone 1 missing Connect Zone 1, check address of Zone 1
Zone 2 missing Connect Zone 2, check address of Zone 2
Software version option incompatible:
Analog Option, Digital Option, Heating current monitor-
ing, Reversal of direction of rotation, Profibus, Profinet,
Ethernet/IP, CAN Demag, CANopen
Update the software
Option missing or faulty:
Analog Option, Digital Option, Heating current monitor-
ing, Reversal of direction of rotation, Profibus, Profinet,
Ethernet/IP, CAN Demag, CANopen
Connect the corresponding option or switch off in the
parameter Hardware Options
To Next Page
Loading...